Logic MG150 User Manual - page 13
2.2 - First Time System Setup
To set up MG150 Series for the first-time, you should have the following items ready.
These items are either included in the accessory box or available from your local
computer parts store.
0*6HULHV8WLOLW\&',QFOXGHG
3RZHUFRUG,QFOXGHG
36$7RU86%.H\ERDUG1RWLQFOXGHG
36RU86%0RXVH1RWLQFOXGHG
86%&'520'ULYH1RWLQFOXGHG
2SHUDWLQJ6\VWHP26,QVWDOODWLRQ&'1RWLQFOXGHG
2.2.1 - Hardware Installation Procedure
(Prior to turning the power on)
1. Connect a PS/2 keyboard or AT keyboard to the PS/2 keyboard port, or a USB
keyboard to a USB port. If you are using an AT keyboard, you need an adapter (AT to
36.%IRUWKLVFRQQHFWLRQ
2. Connect the PS/2 mouse to the PS/2 mouse port, or a USB mouse to a USB port.
3. Connect the male end of the power cord to an electrical outlet.
4. Connect the USB CD-ROM drive.
5. Connect the female end of the power adapter cord to the AC inlet located at the
rear side of the MG150 Series.
2.2.2 - System BIOS Setup
If you are a commercial user, the MG150 SERIES should have been set up and
configured by your distributor already. In the case where you may find it necessary to
change some system configuration information, you will need to run the Basic Input
Output System (BIOS) setup program. Under the following conditions, the CMOS
settings may be changed:
1. The system is starting and being configured for the first time with new components.
2. The hardware devices attached to the MG150 SERIES system have been
changed.
3. The CMOS memory has lost power and the configuration information has been
erased.
- 12 -
MG150 User Manual