M-Audio DCP-300 User Manual - 12 Appendices
User Guide
56
DCP-300
12 Appendices
Appendix A – Defaults
Default Settings
The table below shows the DCP-300 factory default settings and whether or not user changes to these
settings are retained after a power-cycle (turning the device off and on):
Parameter
Factory Default
Retained on Power-Down
Program Number
& Voice Selected
0
No
Voice Button Bank Selection
Off
No
Bank MSB Number
0
No
Bank LSB Number
0
No
Transmit Channel
00 (channel 1)
No
Octave shift
0
No
Transpose
0
No
Local
On
No
Data Control Assignment
Data = cc: 007 Volume
Yes
Data Control Value
(per assignment and only CC - not
including PGM or Bank LSB/MSB)
Value of cc:007
Yes
Velocity Curve Selected
‘NORMAL’
Yes
Voice Volume
127
Yes
Metronome Volume
127
Yes
Master Tune
0
Yes
Tempo
120
Yes
Reverb On/Off
Reverb On
Yes - store for each sound
Reverb Depth
Defaults for each sound
Yes - store for each sound
Reverb Type
Defaults for each sound
Yes - store for each sound
Chorus On/Off
Chorus Off
Yes - store for each sound
Chorus Depth
Defaults for each sound
Yes - store for each sound
Chorus Type
Defaults for each sound
Yes - store for each sound
Split Mode On/Off
Off
No
Split Point
Eb3
Yes
Split Mode Voice
8 - Upright Bass
Yes
Split Volume
127
Yes
Layer Mode On/Off
Off
No
Layer Mode Voice
7 - Strings
Yes
Layer Volume
100
Yes
At power-on, the following MIDI data will be sent to the sound engine, the USB MIDI and the MIDI Out:
1. Bank Change MSB=0, LSB=0, PGM=0 - Set sound engine to piano voice
2. Reverb default value
3. Chorus default value