Summary of DX4
Page 1
Studiophile dx4 user’s guide.
Page 2
Caution: attention: precaucion: to prevent electric shock do notusethis (polarised) plugwithan extension cord, receptacle or other outlet unless the blades can be fully inserted to preventblade exposure. Pour prevenir les chocs electriques ne pas utiliser cette fiche polarisee avec un prolongateur. ...
Page 3: Introduction
3 introduction thank you for choosing the studiophile dx4 professional desktop audio monitoring system. Top recording engineers and producers in studios around the world use m-audio’s studiophile series monitors. With the studiophile dx4s, you can enjoy the same professional standard of audio qualit...
Page 4: Front
4 enclosure - just as the other components do, the dx4’s enclosure plays an important role. In order to provide more stable performance, the dx4’s enclosure employs a special high-density mdf and unique interior reinforcement designed to absorb vibration and impact generated under extreme conditions...
Page 5: Rear
5 5. Headphone output jack: this 1/8” jack outputs a stereo signal identical to the dx4’s speaker output. When headphones are plugged into this jack, the dx4 speakers are muted and headphone volume is controlled using the volume control. Rear note: this image shows the rear panel of the left speaker...
Page 6: Installation
6 for balanced wiring, a three-conductor trs plug is necessary. The input wiring of the trs input connector is as follows: note: input from the trs and rca connectors is summed together, allowing both inputs to be used simultaneously. 3. Mid-boost selector switch: this 2-position switch selects the ...
Page 7: Speaker Wire Connection
7 correct power operation: since the dx4 contains amplifiers; it must be connected to a power outlet using the detachable ac cable that is provided. Before connecting power, please make sure that the voltage of the dx4 corresponds with the voltage you are going to plug the power cord in. Warning! - ...
Page 8: Placing The Dx4
8 setting the mid-boost eq switch this 2-position switch allows you to select either the “in” or “out” mid-boost mode. The out mode produces a flat midrange response for normal monitoring and listening conditions. The in mode will move the sound stage forward toward your listening position. Placing ...
Page 9
3. Place the left and right dx4 units verticallyand right side up. Placing the dx4 monitors horizontally is not recommended. Important: do not place any obstacles that may block the flow of air in front of or between the dx4 monitors. Also, remove reflective materials such as glass, mirrors or metal...
Page 10: Warranty Information
10 warranty information warranty terms m-audio warrants products to be free from defects in materials and workmanship, under normal use and provided that the product is owned by the original, registered user. Visit www.M-audio.Com/warranty for terms and limitations applying to your specific product....
Page 11: Appendix B - Block Diagram
11 appendix b - block diagram 1” hf driver left speaker 2.2khz r-line 1” hf driver power amp r-trs 4” lf driver l-line mid-boost headphones l-trs speaker terminals right speaker 2.2khz 4” lf driver balanced input amp power amp mid-boost balanced input amp crossover crossover mid-boost switch master ...
Page 12
All the safety and operating instructions should be read before the appliance is operated. The safety and operating instructions should be retained for future reference. All warnings on the appliance and in the operating instructions should be adhered to. All operating and use instructions should be...