M-Audio NRV10 User Manual - page 20

NRV10 User Guide         

|

         20

<  

Set the Phones Source switch (29) to Monitor

<  

 Setting the Pre/Post-EQ switch (26) to Pre-EQ will send the NRV10’s input signals to the DAW before the 

channel EQs. Setting it to Post-EQ will send the signals to the DAW after the EQ. 

<    

Set your DAW Software Monitoring to on if you wish to hear the return of your tracks from your DAW. 

Set it to off if you want to listen to the channel inputs.

    Important: When using this monitoring scheme, be careful not to create a feedback loop. When the Channel 

Source switch (6) is in the FW (down) position, do not move the Pre/post-EQ switch (26) to the Post-EQ 

(down) position. Doing so will send the post-EQ signal to the DAW, while returning the same signal to the mixer 

before the EQ, resulting in an audible feedback loop, which can damage your hearing as well as your equipment.

Returning Tracks from Your DAW

After you’re done recording, select any of the NRV10’s outputs 1 through 8 as they appear in your DAW as the output 

for each channel you wish to route to the NRV10. Move the Channel Source button (6) to the FW (down) position for 

the input channel(s) you have routed to.

The Digital Effects Processor

11

T

he NRV10 gives you an integrated digital effect processor, offering 16 presets with 16 settings per preset, for a total of 256 

possible effects. Use the Aux 2 send control to send input signal to the effects processor.

The following programs are available:

1. 

Short Room

2. 

Room

3. 

Small Hall

4. 

Large Hall

5. 

Short Plate

6. 

Vocal Plate

7. 

Cathedral

8. 

Gated Reverb

9. 

Mono Echo

10.  Stereo Echo

11.  Chorus Medium

12.  Chorus Deep

13.  Flange Medium

14.   Echo + Vocal Plate

15.   Chorus + Hall Reverb

16.  Flange + Delay