M Design INTERRA 60 Installation Manual - page 5
INSTRUCTION FOR INSTALLATION AND USE 60-68-74
5
IF THERE IS GREASE OR SOME DUST LAYER ON THE GLASS (INSIDE OR
OUTSIDE), CLEAN IT BEFORE USING GAS FIREPLACE. CLEANING OF THE
GLASS IS THE ONLY MAINTENANCE THAT CAN BE PERFORMED BY
CUSTOMERS.
2
INSTALLATION
This equipment should be accompanied by experts and according to the latest regulations.
Based on the specifications from your order, the device is designed for either natural gas or
propane.
Before installing and commissioning the fireplace into operation, read the instructions and
check local laws and this type of fireplace (indication of the type of gas, etc.) and whether the
device is suitable for your installation conditions.
The installer must comply with the following requirements:
The device must be checked for leaks and the elimination of the flue gas.
The concentric pipes should be tested.
The performance of the control valve, the ignition of the flame, the main burner, and
thermocouple must be tested.
This device has been designed as closed.
Closed (sealed) parts cannot be changed, therefore, it can be also used in enclosed spaces
and spaces fitted with mechanical ventilation of the house. Even in houses with closed
ventilation, where acts as a room heater.
Remark: In some situation it is easy to install the fireplace with an optionally stand.
2.1
GAS CONNECTION
Connection can be performed only by qualified experts!