M-LOCKS Bravo BR5010 Technical Manual - page 2
M-LOCKS BV
Tel: +31 (0)314 376 876
Vlijtstraat 40
ver. 1.1 2010 07 19
Fax: +31 (0)314 376 878
NL-7005 BN Doetinchem
2
www.m-locks.com
STATIONARY MOUNTING:
The diameter of the cable hole should be minimum 9 mm, maximum 12 mm. The hole must
be de-burred well to avoid damage to the cable.
The Bravo entry unit can now not be removed after installation!
Connect one (1) battery to the battery clip. Only use 9V ALKALINE Duracell/ Procell- or
Energizer batteries.
This mounting instruction is part of VdS certification and has to be followed up
precisely.
Prepare the mounting and cable holes according to picture
Hold the bearing plate in a way against the mounting surface that
“UP” is readable on top. Affix the plate with the two mounting
adapter screws (M4) hand tied.
Insert first the spring and then the pin into the hole on the back
cover
Route the cable through the cable hole, hold the unit at the
(approximately) 10:00 o’clock position and slide it on the
mounting adapters.
Turn unit clockwise until it clicks into a stationary position at
12:00.