M-system R7G-SC-SHL Instruction Manual
R7G-SC-SHL
P. 1 / 6
EM-7817-A Rev.1
GATEWAY MODULE
MODEL
R7G-SC-SHL
INSTRUCTION MANUAL
BEFORE USE ....
Thank you for choosing M-System. Before use, please check
contents of the package you received as outlined below.
If you have any problems or questions with the product,
please contact M-System’s Sales Office or representatives.
■
PACKAGE INCLUDES:
Gateway module ........................................................... (1)
■
MODEL NO.
Confirm Model No. marking on the product to be exactly
what you ordered.
■
INSTRUCTION MANUAL
This manual describes necessary points of caution when
you use this product, including installation, connection and
basic maintenance procedures.
POINTS OF CAUTION
■
GENERAL PRECAUTIONS
•Beforeyouremovetheunitormountit,turnoffthepower
supply and input signal for safety.
■
ENVIRONMENT
•Indooruse
•Whenheavydustormetalparticlesarepresentintheair,
install the unit inside proper housing with sufficient ven-
tilation.
•Donotinstalltheunitwhereitissubjectedtocontinuous
vibration.Donotsubjecttheunittophysicalimpact.
•Environmentaltemperaturemustbewithin-10to+55°C
(14to131°F)withrelativehumiditywithin30to90%RH
in order to ensure adequate life span and operation.
■
WIRING
•Do not install cables (power supply, input and output)
close to noise sources (relay drive cable, high frequency
line, etc.).
•Do not bind these cables together with those in which
noisesarepresent.Donotinstalltheminthesameduct.
■
AND ....
•Theunitisdesignedtofunctionassoonaspowerissup-
plied,however,awarmupfor10minutesisrequiredfor
satisfying complete performance described in the data
sheet.
X10
X1
STATION ADD.
PWR
RUN1 RUN2
6M
12M
C1
H1
H
C
C2
H2
HLS
RUN1 ERR1 SD1 RD1
RUN2 ERR2 SD2 RD2
X10
X1
STATION ADD.
B.RATE
CC-Link
TERM
TERM
ON
OFF
ON
OFF
Operating Mode Setting DIP SW (SW1)
CC-Link Baud Rate Setting Rotary SW
CC-Link Station Address Setting Rotary SW
CC-Link Terminating
Resistor SW
CC-Link Status Indicator LED
CC-Link Terminals
Power Supply
Terminals
HLS RJ-45 Connectors
HLS Terminating Resistor SW
HLS Module Address Setting Rotay SW
HLS Status Indicator LED
COMPONENT IDENTIFICATION