M.T.H. Tinplate 840 Operator's Manual - Assembly
Tinplate 840 Powerhouse
3
Assembly
Smoke Stacks
1. Carefully remove the number 840 Powerhouse and styrofoam packing from the
contatiner.
2. Make sure all three hoses from the
smoke unit are sticking up from the
roof. One hose in each hole in the roof
should be visible. If the ends of the
hoses are inside the building. Reach in
through one of the openings below the
skylights and thread the hose through
the openings in the roof for the
smokestacks.
3. Make sure the special locking
screws for the smokestack are aligned
so that the straight sides of the heads
are facing each other.
4. Thread one hose into each
smokestack.
5. Make sure the ends of the hoses
stick out of the top of the smokestack.
A pair of needle-nose pliers may be
needed to grab onto the hoses and guide them through the top of the smokestacks.