M2 MC2125PALS Service Manual - page 21

22

Evaporator Fan Motor is located in the back side

of the cover evaporator assembly.

1. Remove the screws(4pcs) that secured the

Fan motor assembly on the 4 corner.

2. Remove the motor case by removing another

screw and take out the motor.

Evaporator is located in the bottom of freezer

to produce cold air driven across evaporator 

coils.

1. Remove ice bucket and the Ice maker.

2. Remove the cover multi freezer assembly.

3. Remove the cover evaporator assembly.

4. Disconnect the wire connectors.

5. Desolder the inlet and outlet tubes.

6. Take the steps in opposite to seal the

system as mentioned above.

The thermistor is located at inside the upper

hinge cover it sends temperature signal to the

micro-processor.

Ice Maker Thermistor is located bottom of ice

tray. it sends temperature signal to the

micro processor.

Evaporator Fan motor

Ambient Thermistor

Ice Maker Thermistor

Evaporator

Ambient

Thermistor

Thermistor(Ice-Maker)