M2 MC2125PALS Service Manual - page 24
Manual is about: SIDE-BY-SIDE
of
86
25
7-3. Machine compartment
1) Disconnect the compressor cover by releasing
the screws(6EA).
2) Remove the screws which are securing the
electric box. and press the tap in electric box
coverto take outbyusing a flat-blade screw
driver.
The condenser fan is located in the middle of
machine compartment it cools down the sub-
condenser and compressor.
1) Disconnect the wire connector of Fan.
2) Remove the screws (1 EA) on the drain water
tray.
3)Take out the condenser fan assembly.
The sub-condenser is located in the machine
compartment.
1) Desolder the compressor discharge & the
outlet of sub-condensor.
2) Take out the sub condenser.
Machine Compartment & Electric Box
(+)
driver
(-)
driver
PCB-MAIN ASSY
Condenser Fan
Sub-condenser
Desoldering Point