The micro + 3d printer user manual.
Welcome to 3d printing! Thank you for purchasing the micro+ 3d printer, the first truly consumer 3d printer. The micro+ is ready right out of the box to make your custom creations come to life. Just plug in the printer, download the models, hit print, and watch as you bring an object into the world ...
1.0 unboxing the micro+ 1. Lift the micro+ from its packaging box. Remove all bubble wrap, foam, and tape (may require scissors). 2. Inside the micro+ is an accessories box with a usb a-b cable and your country specific power supply. Be sure to remove the “gantry clips” located on the front left and...
2.0 downloading m3d software 1. Please visit http://www.Printm3d.Com/downloads to download your operating system specific m3d software. Download the m3d software to a known location, like your desktop. Run the installer and continue through all windows and prompts. 2. Run the m3d software after it h...
4.0 installing 3d ink (filament) filament installation is accessed by selecting the 3d ink button in the top left corner of the m3d software. You will be guided to install filament externally or internally . Do not attempt to load both ports at the same time during printing. *note factory fi...
5.0 the first print! 1. Quick calibrate often a successful first print layer leads to a successful print! To be sure your printer is ready for its first print, select the gear icon to open the printer settings. Then go to the calibration section where you can select advanced calibration. Now select ...
6.0 troubleshooting in the event of printer issues, visit the m3d support page online at http://www.Printm3d.Com/support . search our technical articles, videos, and documentation for troubleshooting solutions or contact customer support. For additional language support please visit http://www...
Safety safety and warnings: choking hazard - the micro +3d printer and its consumables may include small parts that may constitute a choking hazard; additionally, these products may be used to manufacture objects that may themselves constitute a choking hazard. The micro + 3d printer is not a toy; c...
Legal conditions m3d end user agreement: this agreement between m3d llc (a company incorporated under the laws of the state of maryland in the united states), and you, the end-user, which describes important disclaimers, indemnity, safety instructions, software information, and limited warranty info...
Www.Printm3d.Com "m3d", 3d ink, and print anything" are registered trademarks of m3d llc in fulton, md.
