MABIS Deluxe SmartRead Plus 04-278-001 Instruction Manual - page 9
15
7. Once the systolic pressure is reached, the
cuff will exhaust all air.
8. Your blood pressure (systolic and diastolic)
measurement and pulse rate will be
simultaneously displayed, Fig. 7.
9. Your reading will be automatically stored in
memory.
10. The WHO Indicator, located to the right of
the digital display, Fig. 8, will indicate your reading
in a range (normal, high-normal, high) in
accordance with standards set by the World Health
Organization (WHO), (see chart below).
11. To conserve energy, press the POWER Button to
turn the unit off. Otherwise, the unit will
automatically shut off after approximately 2 minutes.
Fig. 7
Fig. 8
Systolic
Diastolic
Pulse
14
Taking Your Blood Pressure Reading
Proceed only after reading the previous sections of this manual.
1. Position the monitor on a flat, stable surface with
the digital display in view. Insert the cuff tubing
connector into the left side of the monitor, Fig. 1.
2. Rest your elbow on a solid surface with your
palm facing upward. Elevate your arm so that
the cuff is at the same level as your heart, Fig. 2.
Relax your left hand.
3. Press the POWER Button. The unit will run a
self-test, Fig. 3.
4. After the self-test, the values for the last reading
will appear on the display, Fig. 4.
5. The cuff will automatically begin to inflate, with
the display showing the increasing pressure in
the cuff. As the pressure increases, an arrow
pointing up will appear on the display, Fig. 5.
6. Upon reaching the optimum level, the display will show the decreasing
pressure, Fig. 6, by displaying an arrow pointing down.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6