1. DL manuals
  2. MACCHIAVALLEY
  3. Coffee Maker
  4. Tasman-Denali
  5. Installation And Use Manual

MACCHIAVALLEY Tasman-Denali Installation And Use Manual

Summary of Tasman-Denali

  • Page 1

    Lb. 00151-00-gb pag. 1 02/08/06 installation and use manual - at-mega 256 - gb english lb.00151.00.Gb edition july 2006.

  • Page 2

    Lb. 00151-00-gb pag. 2 02/08/06 table of contents introduction and general instructions .............................................................................................................................. 3 instructions for installation.........................................................

  • Page 3

    Lb. 00151-00-gb pag. 3 02/08/06 introduction and general instructions thoroughly read the instructions contained in this booklet because it gives important informat ion regarding safety for installation, use and maintenance. Keep this booklet in a safe and accessible place for further consultation. ...

  • Page 4

    Lb. 00151-00-gb pag. 4 02/08/06 machine keypad key reference tasman -denali lm tasman-denali cof tasman denali self lm tasman-denali self cof coffee group 1 espresso 1 espresso espresso espresso 2 cappuccino 2 espresso espresso macchiato coffee 3 ristretto 1 coffee disable disable 4 latte macchiato ...

  • Page 5

    Lb. 00151-00-gb pag. 5 02/08/06 electric - hydraulic connection 200v-1+n-50/60hz 400v-3+n-50/60hz 200v-3 -50/60hz 230v-1+n-50/60hz 230v-3 -50/60hz 120v-1+n-50/60hz h2o in (1-5 bar) h2o out water softner water filtre.

  • Page 6

    Lb. 00151-00-gb pag. 6 02/08/06 starting up warning: every time that you power on the machine, any smart card must be removed from the slot otherwise the display will show the following error message: card error after having connected the machine to the water and electric networks, turn the switch o...

  • Page 7

    Lb. 00151-00-gb pag. 7 02/08/06 press the key n°11( on/off ), the display shows: filling - up steam boiler during this stage the steam boiler is being filled up. Warning: the solenoid valve of the steam nozzle automatically opens to release the air inside the boiler. When the steam boiler has been f...

  • Page 8

    Lb. 00151-00-gb pag. 8 02/08/06 if the display shows: select drink coffee not ready the displayed message indicates that the set up heating temperature in the coffee boiler has not been reached yet, and therefore coffee based dispensing are not enabled if the display shows: select drink steam not re...

  • Page 9

    Lb. 00151-00-gb pag. 9 02/08/06 coffee, cappuccino, milk dispensing 1) machine configurations standard the display shows: select drink place a cup under the adjustable in height coffee dispenser, and press the dose key required. The display shows: xxxxxx ¯ ¯ ¯ ¯ ¯ ¯ ¯ ¯ ¯ ¯ where “xxxxxx” indicates ...

  • Page 10

    Lb. 00151-00-gb pag. 10 02/08/06 3) machine configurations self the display shows: select drink place a cup under the coffee dispenser and press the dose key required. The display shows: xxxxxx ¯ ¯ ¯ ¯ ¯ ¯ ¯ ¯ ¯ ¯ where “xxxxxx” indicates the selected dose key name. The cursor indicates the amount o...

  • Page 11

    Lb. 00151-00-gb pag. 11 02/08/06 xxxxxx ¯ ¯ ¯ ¯ ¯ ¯ ¯ ¯ ¯ ¯ where xxxxxxxx is the name of the selected drink. The cursor indicates the amount of drink being dispensed. Warning: a) on-off button is enabled only when the smart card is inserted b) when pressing the selection button before inserting coi...

  • Page 12

    Lb. 00151-00-gb pag. 12 02/08/06 continuous dispensing with butto n°17 the “ continuos “ function for button n°17 is enabled only if in “parameters machine“ the parameters “ button 17 function ” has been programmed as continuos. Press the key n°17 as many times as the number of doses you want to dis...

  • Page 13

    Lb. 00151-00-gb pag. 13 02/08/06 hot water dispensing place a cup under the hot water outlet, and press the hot water key dose n°9. Dispensing will be automatically stopped once the programmed dose is over. The display shows: hot water ¯ ¯ ¯ ¯ ¯ ¯ ¯ ¯ ¯ the cursor indicates the amount of drink being...

  • Page 14

    Lb. 00151-00-gb pag. 14 02/08/06 system clock programming n:b: the system clock parameters are available only with the system clock enable. To enter in system clock programming, proceed as follows. With smart-card: insert the owner or waiter smart card into the proper slit and keep pressed the key n...

  • Page 15

    Lb. 00151-00-gb pag. 15 02/08/06 automatic rinsing cycle 1) automatic group rinsing. A timed rinsing cycle of the brewing chamber is automatically carried out 15 minutes after the last dispensed drink and every 180 minutes when the machine is in stand-by mode. The display shows: group autocleaning p...

  • Page 16

    Lb. 00151-00-gb pag. 16 02/08/06 access the main setting menus with password or smart-card a) access the main setting menus with password to enter the programming environments, a password is required which define the access rights to the different environments. The password must be composed with 5 n...

  • Page 17

    Lb. 00151-00-gb pag. 17 02/08/06 key reference for password.

  • Page 18

    Lb. 00151-00-gb pag. 18 02/08/06 b) access the main setting menus with smart card to enter the programming environments , insert one of the following smart cards into the proper slit with the machine in off: : - waietr smart card - roaster- smart card - owner smart card the display shows : select in...

  • Page 19

    Lb. 00151-00-gb pag. 19 02/08/06 programmable parameters in according with password or smart cards system manager password or smartcard waiter password or smartcard roaster password or smartcard owner info - reset dose data x* x* x system data dose slight adj. X x x dose programming calibration mach...

  • Page 20

    Lb. 00151-00-gb pag. 20 02/08/06 read and reset data to enter in read and reset data , proceed as follows. With smart-card: insert the owner smart card into the proper slit and with machine in off keep pressed the key n°17 (enter) . With password : digit the owner password . The display shows : info...

  • Page 21

    Lb. 00151-00-gb pag. 21 02/08/06 with this operation we reset only the doses count – extra milk and total cashing + / - no yes enter + / - reset doses data x enter reset doses data please confirm enter reset doses data enter press the + / - keys to select the count a or b..

  • Page 22

    Lb. 00151-00-gb pag. 22 02/08/06 info system data to enter in info system data , proceed as follows. With smart-card: insert the owner smart card into the proper slit and keep pressed the key n°17 (enter) . With password : digit the owner password . The display shows : info reset system data group c...

  • Page 23

    Lb. 00151-00-gb pag. 23 02/08/06 the following info are displayed only when the clock is programmed machine service xxxx yy - zzzz xxxx : indicates the n° of group cycles left. If the programmed n° of group cycles exceed the display shows: ( - xxxx ) yy : indicates the maintenance month zzzz : indic...

  • Page 24

    Lb. 00151-00-gb pag. 24 02/08/06 doses slight adjust programming please note : to access to the doses slight adjust the machine must be at the set-up temperature. To enter in doses slight adjust programming mode, proceed as follows. With smart-card: insert the owner or roaster smart card into the pr...

  • Page 25

    Lb. 00151-00-gb pag. 25 02/08/06 set doses price programming please note : to access to the set doses price the machine must be at the set -up temperature. To enter in set doses price programming mode, proceed as follows. With smart-card: insert the owner smart card into the proper slit and keep pre...

  • Page 26

    Lb. 00151-00-gb pag. 26 02/08/06 shift doses slight adjust programming please note : to access to the shift doses slight adjust the machine must be at the set -up temperature. By means of the shift button, is possible to adjust other 10 doses for a total number of 20 drinks . To enter in shift doses...

  • Page 27

    Lb. 00151-00-gb pag. 27 02/08/06 set shift doses price programming please note : to access to the set shift doses price the machine must be at the set -up temperature. To enter in set shift doses price programming mode, proceed as follows. With smart-card: insert the owner smart card into the proper...

  • Page 28

    Lb. 00151-00-gb pag. 28 02/08/06 automatic cleaning of coffee group please note: a) the cleaning cycle is disabled after a time out of 30 seconds in any stage before inserting the detergent, except when the machine door is open. B) the cleaning cycle cannot be interrupted after the detergent has bee...

  • Page 29

    Lb. 00151-00-gb pag. 29 02/08/06 automatic cleaning of milk frother please note : at the end of the washing cycle the display will show: - put the milk infeed pipe into a glass of cold water - press the key “ t2 “, the cappuccino maker will start dispensing another cleaning cycle only with water. Pl...

  • Page 30

    Lb. 00151-00-gb pag. 30 02/08/06 manual cleaning of milk frother and coffee outlet please note: a? Foam setting the milk frother is equipped with a foam regulator which sets the quantity of air needed for frothing milk. Turn the ring nut clockwise for thicker foam (small bubbles), or turn it anticlo...

  • Page 31

    Lb. 00151-00-gb pag. 31 02/08/06 manual cleaning of barista steam other recommended cleaning hopper cleaning ground bin cleaning nt- 00761 3? Unscrew the external tube of the barista steam . 2? Clean the barista steam by means of a cloth. 1? Leave barista steam into hot water for 5 minutes. 6? Screw...

  • Page 32

    Lb. 00151-00-gb pag. 32 02/08/06 machine functions messages 1) full grounds bin alarm. Grounds bin full cause: grounds bin full. The number of coffee grounds in the bin has reached the value set in the programming phas e. Result: shutdown of the coffee based dispensing keys. Solution: remove the gro...

  • Page 33

    Lb. 00151-00-gb pag. 33 02/08/06 6) message of empty hopper the display will shows the following message: empty hopper cause: there is not coffee into the hopper and therefore into the brewing chamber. Result: the machine interrupts the coffee-based dispensing selections . Solution: press the ( clea...

  • Page 34

    Lb. 00151-00-gb pag. 34 02/08/06 the macchiavalley s.P.A. Product you have purchased is subject to directive 2002/96/ec of the european parliament and the council of the european union on waste electrical and electronic equipment (weee) and, in jurisdictions adopting that directive, is marked as bei...