Mackenzie MacFi-se User Manual

Other manuals for MacFi-se: Enhanced Operation Addendum

Summary of MacFi-se

  • Page 1

    __________________ __________________ __________________ return address mackenzie laboratories, inc. 1163 nicole court glendora, ca 91740 usa --------------------------------------------------------------------------------------------------------------- other mackenzie product lines message on hold ...

  • Page 2

    General safety instructions always follow these basic safety precautions when using the system: 1. Read carefully and understand all instructions. 2. Follow all warnings and instructions marked on the product. 3. Do not block or cover ventilation slots and openings. 4. Do not place the product in a ...

  • Page 3

    Notes __________________________________________________________________ __________________________________________________________________ __________________________________________________________________ __________________________________________________________________ __________________________...

  • Page 4

    Shipping container contents the following items should be found in the container of macfi-se, mp3 digital audio record/play system: ▪ macfi-se system ▪ installation and user guide ▪ set of four rubber feet hardware configurations ▪ macfi-se; 99 messages, 17 hours + of mp3 playback / recording, rs-23...

  • Page 5

    5. Warranty, service & returns the industrial grade housing and quality construction of the mackenzie macfi-se virtually eliminates the need for service or maintenance. There are no user-serviceable components within the mackenzie macfi-mp. Refer all servicing to the factory. 5.1 warranty coverage: ...

  • Page 6

    The macfi-se version also includes the following features: rs-232 (serial) control of recording and playback rs-232 (serial) download of mpeg layer 3 (mp3), or wav files. Synchronization relay front mounted controls usb memory key interface general specifications audio coding: recording: mpeg 1, lay...

  • Page 7

    Step 1 – make all desired power, audio out, configuration switch and i/o connections to the unit and power up. Unit will perform a self test and enter idle mode. Step 2 – provide a momentary or maintained contact closure between the message input (connector 1, terminals 2-9) and common (connector 1,...

  • Page 8

    2. Installation & configuration this section provides complete instructions for mounting the macfi-se, mp3 digital audio record / play system on a wall or table. It also illustrates all interface requirements to auxiliary equipment, including inputs and outputs. Configuration switch settings are pro...

  • Page 9

    3. Operation 3.1 recording - local local recording is achieved through the led’s and buttons located on the top of the macfi-se unit. Please reference the manual button & led configuration section of this manual for additional information on functions. Step 1 – make all desired power, audio in, audi...

  • Page 10

    Play method defines playback mode of message sequences. Message sequences are comprised of the message material, number of plays and delay between plays. 5 6 standard operation - details below play one sequence per closure - details below play while active - details below re-trigger - details below ...

  • Page 11

    If a message is setup for recording, the record led will be blinking and the message location will be displayed on the message number display, pressing this button will initiate the recording process. Pressing it again, with the recording in process, will stop the recording. Pressing this button wit...

  • Page 12

    Play next enabling play next allows start 8 input (connector 1, pos. 9) to initiate playback of the next valid message sequence. The first start activation after power on will play message 1. All operation modes are supported and other start inputs (1 - 7) are disabled. 7 disable enable memory prote...

  • Page 13

    2.2.10. Audio out spkr bridged, mono speaker output for playing messages. 2 position terminal connector. 4 watts into 8 ohms or 6 watts into 4 ohms. Caution: referencing either of the speaker output terminals to ground will cause incorrect operation and may damage the unit. Always connect the speake...

  • Page 14

    14 15.