Mackie Digital X Bus Dissambly Instruction - What You Need
2
Mackie Digital X Bus
Getting Inside the Digital X Bus
3
Mackie Digital X Bus
Getting Inside the Digital X Bus
What You Need
You only require three tools to perform this procedure:
• A new condition #2 Philips head Screwdriver (Figure A, below left).
• Flathead “Jeweler’s” Screwdriver (Figure B, below right)
• Anti-static Wrist Strap
Before You Start
You’ll need to do the following things before starting to open up your Digital X Bus:
• Make sure the console is completely shut off and unplugged from any AC power source.
• Unplug all audio and sync cables from the rear panel.
• Unplug any USB peripherals, mouse, keyboard, or anything other cables attached to the
rear panel.
• Place the Digital X Bus on a surface larger than the console, away from any carpeting or
static-prone area(s). This surface will need to extend beyond the rear side of the Digital
X Bus by at least two-three feet (or one meter) of distance, because the rear panel will
eventually slide out (like a drawer) and you will need to make sure it is supported and
doesn’t fall out of the mixer.
• Put on the anti-static wrist strap and connect the end of the cord to the metal chassis of the
Digital X Bus (Figure C).
Note: We recommend using an area that provides access to all sides of the Digital X Bus,
such as a table in the middle of a room…or something similar.
Figure A
Figure B
Figure C