Mackie Digital X Bus Dissambly Instruction - Removing The Com Cable
4
Mackie Digital X Bus
Getting Inside the Digital X Bus
5
Mackie Digital X Bus
Getting Inside the Digital X Bus
Removing the COM Cable
Once you can see the Motherboard Access Area, look for a small rainbow or grey colored
ribbon cable (called the COM Cable) attached to the motherboard’s COM port in the lower left
hand corner of the Motherboard Access Area. If you see it there, then you need to remove it.
Locate the two small silver screws on either side of the COM Cable connector. Using your
Flathead “Jeweler’s” Screwdriver, unscrew those two screws (as shown in Figure F) and discon-
nect the COM Cable from the COM port (as shown in Figure G):
Note: Make sure you do not pull on the COM Cable, or you may damage the header on the
other end of that COM Cable.
Figure F
Figure G