Mackie ProFX12 Owner's Manual - “Xlr” Connectors
27
Owner’s Manual
Owner’
s Manual
“XLR” Connectors
-ACKIEMIXERSUSEPINFEMALEh8,2vCONNECTORSON
all microphone inputs, with pin 1 wired to the grounded
(earthed) shield, pin 2 wired to the “high” (“hot” or
positive polarity) side of the audio signal and pin 3
wired to the “low” (“cold” or negative polarity) side of
the signal. See Figure A. This is all totally aboveboard
and in full accord with the hallowed standards dictated
by the AES (Audio Engineering Society).
Use a male “XLR”-type connector, usually found on the
nether end of what is called a “mic cable,” to connect to
a female XLR jack.
1
⁄
4
" TRS Phone Plugs and Jacks
“TRS” stands for Tip-Ring-Sleeve, the three
CONNECTIONSAVAILABLEONAhSTEREOvbORhBALANCEDv
phone jack or plug. See Figure B.
TRS jacks and plugs are used in several different
applications:
s 3TEREOHEADPHONESANDRARELYSTEREO
microphones and stereo line connections.
7HENWIREDFORSTEREOAb423JACKORPLUG
is connected tip to left, ring to right and sleeve
TOGROUNDEARTH-ACKIEMIXERSDONOT
directly accept 1-plug-type stereo micro phones.
They must be separated into a left cord and a
right cord, which are plugged into the two mic
preamps.
Appendix B: Connections
s "ALANCEDMONOCIRCUITS7HENWIREDASA
BALANCEDCONNECTORAb423JACKORPLUG
is connected tip to signal high (hot), ring to
signal low (cold), and sleeve to ground (earth).
s 5NBALANCED3END2ETURNCIRCUITS7HENWIRED
ASSENDRETURNh9vCONNECTORAb423JACK
or plug is connected tip to signal send (output
from mixer), ring to signal return (input back
into mixer), and sleeve to ground (earth).
1
⁄
4
" TS Phone Plugs and Jacks
“TS” stands for Tip-Sleeve, the two connections
AVAILABLEONAhMONOvbPHONEJACKORPLUG
See Figure C.
TS jacks and plugs are used in many different
applications, always unbalanced. The tip is connected to
the audio signal and the sleeve to ground (earth). Some
examples:
s 5NBALANCEDMICROPHONES
s %LECTRICGUITARSANDELECTRONICINSTRUMENTS
s 5NBALANCEDLINELEVELCONNECTIONS
RCA Plugs and Jacks
RCA-type plugs (also known as phono plugs) and
jacks are often used in home stereo and video
equipment and in many other applications (Figure D).
4HEYAREUNBALANCEDANDELECTRICALLYIDENTICALTOAb
TS phone plug or jack (see Figure C). Connect the
signal to the center post and the ground (earth) or
shield to the surrounding “basket.”
SLEEVE
TIP
TIP
SLEEVE
TIP
SLEEVE
Figure C: TS Plug
2
2
3
1
1
SHIELD
COLD
HOT
SHIELD
COLD
HOT
3
SHIELD
COLD
HOT
3
2
1
Figure A: XLR Connectors
SLEEVE
TIP
SLEEVE
TIP
RING
RING
TIP
SLEEVE
RING
Figure B: 1⁄4" TRS Plugs
TIP
SLEEVE
TIP
SLEEVE
Figure D: RCA Plug