Maco Antennas M108HV Assembly Instructions Manual

Assembly Instructions 

M108HV 

Your Maco 108HV maxibeam is an innovation in base station beam design, which enables the 

vertical and horizontal to be assembled for either 10 or 11 meters. 

For example, using the charts supplied, you can assemble the horizontal for 11 meters and the 

vertical for 10 meters, or reverse this, or assemble both the same. The horizontal and vertical 

do not affect each other, so feel free to set your antenna up whichever way you wish. 

THE ONLY DIFFERENCE BETWEEN THE HV BEAMS AND THE INSTRUCTIONS INCLUDED IS THAT THE 

HV BEAM HAS BOTH SETS OF ELEMENTS ON THE SAME BOOM. 

UU

PLEASE ADD THE FOLLOWING INSTRUCTIONS TO THOSE SUPPLIED: 

Mount the first reflector with the u-bolt facing the rear. Mount its mate with the u-bolt 

facing the front of the beam. This is so the vertical and horizontal elements will be close 

together, but they should not touch. Maintain a 1/4" spacing between the hardware.   

Do the same with all the elements and measure the spacing only once per set of elements. 

Maco Antennas - a Division of Charles Electronics, LLC 

302 S. East St. 

Mt. Carroll, IL 61053 

815-244-3500 

www.macoantennas.net