Maco Antennas M108HV Assembly Instructions Manual - page 3
REFLECTOR
BLACK PLASTIC
ELEMENT
DIRECTOR
S E C O N D
DIRECTOR
THIRD
DIRECTOR
HORIZONTAL POLARIATION
DIRECTOR
PLASTIC CAP
RADIATION
SIXTH
DIRECTION
O F
RADIATION
RED PLASTIC
CAP
VERTICAL POLARIATION
63
DRIVEN
SECOND
DIRECTOR
BLACK
PLASTIC
CAP
P - 6 )
FIGURE 1
GENERAL INSTRUCTIONS
This drawing shows a view of the antenna assembled. The
may be used horizontally or
vertically. These instructions and FIGURES 2 through 4 show the correct assembly instructions. It is highly
recommended that rope be put in the elements to prolong their life. All hardware should be tightened
securely, and then coated with silicon rubber sealant or similar compound to prevent loosening from wind
vibration.
Take care to locate all parts accurately per dimensions given. Complete each step as instructed before
going on to following steps.
Upon completion of assembly, install the red plastic cap
on the director end of the antenna,
and the black plastic cap (PL6) on the reflector end. This will allow you to determine at a glance the direction
of transmit and receive.
2