Macpower & Tytech D7-3500 User Manual - Tv Setup
D7-3500 User Guide
TV Setup
Find a suitable place for your D7-3500, within a distance of 1.2m or less of your TV screen.
Connect the power supply and the power outlet.
Included with your D7-3500 are a standard AV cable and a YPbPr
cable. Connect it to the A/V connector on the D7-3500 and plug it
into your TV. For the video, use either S-Video (better quality) or if
not available, the yellow RCA connector. For analogue audio, use
the white and red RCA connectors. If your TV supports it, we
recommend using the component cable (YPbPr) for optimum video
quality (up to 720p or 1080i) instead of the standard AV composite
cable.
For Dolby 5.1 surround and digital audio output, we recommend
using the SPDIF optical audio cable. Connect this to your amplifier
or sound system and change the settings for audio output on your
D7-3500 to RAW format and 5.1 surround output.
For content streaming from your computer and the internet, connect
the LAN cable to an Ethernet switch or router. For the wireless
model, content streaming is possible wirelessly using 802.11b or g.
However, for optimum performance and high definition content with
high bitrates, we recommend using the wired LAN connection
option instead of the wireless setup.
Having connected all cables, you are now ready to turn on the power and use the remote
control to turn on the device. Simultaneously, turn on your television set, and select the
A/V channel. Wait a few seconds for the system to boot and you should see the D7-3500
welcome screen.
Note: If everything is setup correctly but you can not see the welcome screen, press the
TV Mode button until you find the right video signal.
Page 10 / Chapter 2 - System Setup