Macro-Tech 24x6 Reference Manual - Illustrations
Page 5
Macro-Tech 24x6 & 36x12 Power Amplifiers
ILLUSTRATIONS
1.1
Macro-Tech 36x12 Amplifier ...................................................... 7
2.1
Front Facilities ........................................................................... 8
2.2
Rear Facilities ........................................................................... 9
3.1
Mounting Dimensions ............................................................. 10
3.2
Top View of a Rack-Mounted Unit ........................................... 10
3.3
Proper Air Flow in a Rack Cabinet ........................................... 10
3.4
Wiring (
a Macro-Tech 36x12 is shown) .................................... 11
3.5
Unbalanced Input Wiring ........................................................ 12
3.6
Balanced Input Wiring ............................................................ 12
3.7
Balanced and Unbalanced Phone Plug Wiring ....................... 12
3.8
Subsonic Filter Capacitors ...................................................... 13
3.9
Unbalanced RFI Filters ........................................................... 13
3.10 Balanced RFI Filters ................................................................ 13
3.11 Wire Size Nomograph ............................................................. 14
3.12 Inductive Load (Transformer) Network .................................... 16
3.13 Loudspeaker Fuse Selector Nomograph ................................ 16
4.1
Indicators ................................................................................ 17
4.2
ODEP and Signal/IOC Indicator States ................................... 18
4.3
Input Sensitivity and Ground Lift Switches .............................. 20
5.1
A Typical Power Supply .......................................................... 21
5.2
Complex Musical Waveforms .................................................. 22
5.3
VZ Supply in Parallel Mode ..................................................... 22
5.4
VZ Supply in Series Mode ....................................................... 22
5.5
Circuit Block Diagram ............................................................. 24
6.1
Typical Frequency Response .................................................. 27
6.2
Typical Damping Factor .......................................................... 27
6.3
Typical Output Impedance ...................................................... 27
6.4
Typical Phase Response ......................................................... 28
7.1
Macro-Tech 24x6 Pwr Draw, Current Draw and Therm Dis ...... 28
7.1
Macro-Tech 36x12 Pwr Draw, Current Draw and Therm Dis .... 29
8.1
Installing a
P.I.P. Module .......................................................... 30
8.2
Installing an MA-LOCK Level Control Shaft Lock .................... 32