MacroAir Technologies Airvolution Installation Manual - page 24
Page
24
MacroAir Technologies Inc. www.macro-air.com Toll Free: 866-668-3247 Build: January 9 2009
Step 8
, Make Final Adjustments And Attach Safety Cable
A)
Fine-tune the horizontal angle. Make sure the nuts are all completely tight.
B)
Pivot the fan to the desired vertical angle and securely tighten all the nuts in the pivot
section.
Always allow one to two inches of clearance between the safety screen and walls or ceiling.
C)
Check that all nuts and bolts are completely tight.
D)
Thread the safety cable through the center hole on the motor mount and pivot below
the gearbox/motor and attach securely to a nearby wall or ceiling. Follow the directions
in step 12 of the standard instructions to properly secure the cable. MacroAir
recommends using an eyebolt securely attached to the wall or ceiling to anchor the
safety cable; this is not included with the fan.