Macsense AeroMouse UM-160 User Manual - page 5
Installation
Hardware Installation
Installing batteries in the mouse(transmitter unit):
1 .Remove the battery cover on the bottom of the AeroMouse.
2 .Insert two AAA batteries into the battery compartment.
3 .Carefully replace the cover.
Connecting the receiver unit to a USB port.
1. Locate the USB port on your Macintosh or PC. It is a flat
rectangular shape port. On the Macintosh, it can be found on
either side (iMac and iBook) or back panel (Power Mac G3/G4).
2. Plug the AeroMouse into the empty USB port firmly.
Note: Do not force the connector if it doesn't fit. In this case, pull
the connector out, confirm its direction, and then try again. When the
AeroMouse is connected properly, the cursor on the screen should
start to respond to mouse movements.
Multi-user Channel Setting
Up to 8 AeroMouse units can be used in the same area. By pressing
the Channel Button on the receiver and transmitter (AeroMouse) the
radio channels can be changed. Typically, the default settings out of the
box will work just fine and changes do not need to be made at all.
Both the receiver and transmitter must be on the same channel to
operate. To change the channel settings, press the Channel Button on
the receiver and transmitter for the desire settings. Each time the
Channel Button is pressed on the receiver and transmitter, the LED on it
will flash accordingly. For example, the first time you press the Channel
Button on the receiver, you should see two flashes indicating that you are
on Channel 2. Pressing the Channel Button again, will make the LED
flash three times indicating you are on Channel 3.(See Figure 2.1)
Note: Pressing the button for more than one second to reset the unit to
channel 1.
Chapter 2 - Installation
2