MadMan NTWB2 Installation & User Manual - 8 Installation
NTWB2
INSTALLATION & USER MANUAL
Page | 11
Rev 1.0
8 INSTALLATION
8.1 Overview
The NTWB2 must be installed in a location that is clean, dry and not subject to high humidity or
extremes of temperature. For optimum performance it should be located such that there are as few
obstructions as possible between it and the WiFi devices to which it will communicate.
All electrical connections are made using the green plug-in connector supplied. The electrical
connections can be made with or without the plug-in connector plugged in to the NTWB2.
The terminals are of the spring type for superior resistance to vibration and no tools are needed to
connect pre-stripped wires.
The terminals also have test probe insertion holes (1mm diameter) to facilitate testing when plugged
in. Refer to
Figure 5
for details of the green plug-in connector.
8.2 Making Connections
The spring terminals of the plug-in connector will accept wires up to 0.5mm
2
(20 AWG). The wires
must be stripped back 8mm (5/16”) and the strands either lightly twisted or crimped in a 0.5mm
2
ferrule.
Figure 4 - Wire Strip Length
Using your fingernail or a small screwdriver, depress the orange button and insert the wire all the
way into the terminal below the orange button. Release the orange button and gently pull on the
wire to ensure it is held in place by the terminal.
Figure 5 - Plug-in Connector