MadMan NTWB2 Installation & User Manual - page 14
NTWB2
INSTALLATION & USER MANUAL
Rev 1.0
Page | 14
9 RESET TO FACTORY DEFAULTS
Follow these steps to reset the NWTB2 back to factory defaults.
1.
Unplug the green wiring connector from the NTWB2.
2.
Remove the cover by removing the 4 black screws.
3.
Locate the ‘Defaults’ pins as indicated in Figure 9 below and install the jumper to
short the pins together.
4.
Plug the wiring connector back in to the NTWB2 and power up.
5.
When the default values are being set all indicator LEDs will be on at the same time
for a short period, after which the normal power up LED sequence occurs.
6.
Remove the jumper from the ‘Defaults’ pins (store the jumper by placing it over one
pin only) and replace the lid.
Figure 9 - Location of 'Defaults' jumper
‘Defaults’
jumper
NOTES:
After restoring the factory default values, use the password that was supplied with
the NTWB2 documentation to connect in AP mode.
The ‘Join’ WiFi parameters (SSID, password) will be cleared when the default
values are reset and the Join mode port will be set to 2000.