Maestro MR260 Owner's Manual - page 4
6
7
- Do not use while bathing or in a shower.
- Never drop or insert any object into any opening on this appliance.
ATTENTION!
Be careful because the heated surface becomes very hot during
operation.
Do not touch the heating elements to avoid burns. Let the device
cool down after switching off.
In case of failure to observe the above rules there arises a
danger of receiving burns!
- Hair sprays and fixers contain inflammable components. Do not
use them when the device is ON. Do not direct sprays of any kind or
water on the device.
- Dry your hair before using the device.
THIS APPLIANCE IS FOR HOUSEHOLD USE ONLY. DO NOT
USE THE APPLIANCE FOR ANYTHING OTHER THAN INTENDED
USE.
- Do not use it for commercial purpose.
Actions in extreme situations
- If your device has fallen into water or water has penetrated it,
immediately disconnect it from the mains without contacting the
device itself or the water.
- If there appears smoke, sparkling, strong smell of burning
isolation, immediately stop using the device, disconnect the device
from the mains and apply to the nearest service center.
Operation
Before startup
- Remove all wrap materials and stickers
- Make sure that all the parts of appliance don’t have damages.
- Unwind the power cord completely.
- Place the device on a flat dry heatproof surface.
- Connect the device to the mains.
The hair must be clean, dry and brushed.
ATTENTION! A small quantity of smoke or a specific smell may
appear after the first switching ON as the result of conservation
materials contact with heating element. This is a normal
phenomenon and it shall disappear after several minutes of
operation.
- To switch the device move the switch (4/Fig.1) forward to the
position «ON», light indicator will flash (5/Fig.1), the device will
begin warming up.
- Wait till the device warms up. Required temperature will be
reached within 3 minutes approximately.
- The hair must be clean and dry without any gel, spray, etc. Use
the strands of hair maximum 5 cm wide and 1 cm thick.
- Place the brush near the hair roots and wind it on the brush
towards to roots. Then pull the hair strand from the roots to the ends
with the brush.
- To create volume place the brush at the roots, curl strands and let
them free.
EN