Mag One BPR 40 Service Manual - page 49
Factory Reset
4-5
1.
Take note of the 10-digit serial number found at the sticker at the radio’s chassis; look for the
number following the “S/N”.
2.
Turn off the radio.
3.
Connect the programming cable to the radio.
4.
Press and hold Programmable Button 1 (top side button on radio) then turn on the radio.
5.
The radio beeps once. Immediately release Programmable Button 1. The radio’s LED
illuminates in orange.
6.
The Dealer Serial Number Programming Tool displays the serial number field. Enter the
correct 10-digit serial number, as noted at step 1 above. The tool does not allow the user to
write the serial number to the radio, unless a complete 10-digit serial number is entered.
7.
Click the Write button. The tool shows a writing progress bar.
5.0
Factory Reset
This feature allows the user to restore the radio to the factory default settings.
1.
Press and hold both the PTT and Programmable Button 2 (the lower programmable button),
while turning on the radio.
2.
The radio emits the Good Key Chirp tone upon completion of the factory reset.
NOTE
Make sure the replacement board can be reprogrammed by following the procedures at “To
read the Radio Serial Number to a PC” on page 4-4.