Mega 2550 2-way lcd pager alarm installation manual megatronix chatsworth, ca usa mega 2550 install 1.
Mega 2550 install 2.
Installation diagram h1: main 5 pin white harness h8: 10 pin white mini connector led indicator valet switch h4 6 pin white h6 4 pin orange h3 2 pin blue h5 2 pin white h7 4 pin black dual zone shock sensor h1 5 pin white h8 10 pin white h4: 6 pin door lock / unlock wire harness two way transceiver ...
Keep wiring away from moving engine parts, exhaust pipes, and high-tension cable. Tape wires that pass through holes on the firewall to prevent frying electrical. Watch out for sharp edges that may damage wires and causes short circuit. Caution: do not connect the wire harness to the control module ...
Shielded window glass as far as possible. There might be an area of the windshield that does not have protection. H8. 10-pin mini connector wire harness. H8/1. Yellow wire – to ignition switched +12v – this wire is connected to a switched 12 volts source. This wire should receive "12 volts" when the...
This will become a 1 second pulse ground by activating channel 3 on the transmitter for two seconds. The current capacity of this wire is 200ma. This feature allows you to remote control the trunk release or another electric device. This output can also be programmed to provide the following type of...
2 step door unlock wire connection for 5 wire alternating door locks +12v cut the existing lock wire green / white blue / red green / red cut existing unlock x blue / white cut the unlock wire lock unlock oem door master lock oem slave door lock switch +12v lock unlock to all other door lock motors ...
B. Alarm features programming: alarm feature “ i ” proramming: 1. Turn the ignition switch ‘on/off’ 3 times and stay in the off position. 2. Push the valet switch 2 times and hold it on 2 nd push until one chirp with a long chirp is heard. Then release the valet switch. You are now in the alarm feat...
Alarm feature “ iii ” proramming: 1. Turn the ignition switch ‘on/off’ 3 times and stay in the off position. 2. Push the valet switch 6 times and hold it on the 6 th push until three chirps with a long chirp is heard. Then release the valet switch. You are now in the alarm feature ‘iii’ programming ...
Alarm feature “ iv ” proramming: 1. Turn the ignition switch ‘on/off’ 3 times and stay in the off position. 2. Push the valet switch 8 times and hold it on the 8 th push until four chirps with a long chirp is heard. Then release the valet switch. You are now in the alarm feature ‘iv’ programming mod...
Test mode in this test mode, this system can test the zone 1 warn away trigger / zone 2 instant ground trigger / zone 3 door trigger and the zone 4 optional sensor sensitivity. The installer can save time to test the optional sensor sensitivity and sensor without using the traditional arming/disarmi...
Mega 2550 install 12.
