Magalarm MEGA 2550 Installation Manual - page 8
B. ALARM FEATURES PROGRAMMING:
ALARM FEATURE “
I
” PRORAMMING:
1. Turn the Ignition switch ‘ON/OFF’ 3 TIMES and stay in the OFF position.
2. Push the Valet switch 2 times and hold it on 2
nd
push until one chirp with a long chirp is heard. Then
release the valet switch. You are now in the Alarm feature ‘I’ programming mode.
3. Press and release the transmitter button ‘A’ corresponding to the feature ‘A’ you want to change.
a. The siren chirps and LED pause will indicate previously setting.
b. The system would advance to [2] LED flash, [2] chirp. (The factory default settings are always [1]
LED flash, [1] chirp.)
4. Depress the transmitter button ‘A’ again to change the feature again. Simple keep re-depressing the
transmitter button ‘A’ again until the module advances to your desired setting.
5. Depress the transmitter button ‘B’ corresponding to the feature ‘B’ you want to program.
Press
Transmitter
Button
One Chirp /
One LED Pulse
Factory Default
Setting
Two Chirps /
Two LED Pulses
Three Chirps /
Three LED Pulses
Four Chirps /
Four LED Pulses
1
All Chirps off
All Chirps on
Siren Chirps on only
Horn Chirps on only
2
Automatic Rearm
off
Automatic Rearm on
3
45 seconds Delay
Door Ajar error
chirp.
Instantly Door Ajar
error chirp
4
Without Car-jack
mode
Active Car-jack
mode
Passive Car-jack
mode
Exit: Turn Ignition to the 'ON' position, or leave it for 15 seconds. 3 long chirps will confirm exit.
ALARM FEATURE “
II
” PRORAMMING:
1. Turn the Ignition switch ‘ON/OFF’ 3 TIMES and stay in the OFF position.
2. Push the Valet switch 4 times and hold it on the 4
th
push until two chirps with a long chirp is heard.
Then release the valet switch. You are now in the Alarm feature ‘II’ programming mode.
3. Press and release the transmitter button ‘A’ corresponding to the feature ‘A’ you want to program.
Press
T
ransmitte
r
Button
One Chirp /
One LED Pulse
Factory Default
Setting
Two Chirps /
Two LED Pulses
Three Chirps /
Three LED Pulses
Four Chirps /
Four LED Pulses
1
0.9-second door
lock pulses.
3.5-second door lock
pulse.
Double pulse unlock
Door lock with
“Comfort Feature”
2
Active arming
Passive arming
without passive door
locking
Passive arming with
passive door locking
3
Ignition controlled
door lock &
unlock
Ignition controlled
door lock only
Ignition controlled
door unlock only
Without ignition
controlled door lock
& unlock
4
Pathway
illumination
feature “off”
Parking light “on” for
30 seconds upon an
unlock signal
Parking light “on” for
30 seconds upon an
unlock signal & 10
seconds upon a lock
signal.
Exit: Turn Ignition to the 'ON' position, or leave it for 15 seconds. 3 long chirps will confirm exit.
Comfort Feature:
Some Vehicles have a special “COMFORT feature”. When you lock the door with the key, you just have to
keep on turning the key on the door about 5 or 7 seconds and the window will close directly.
If your vehicle with “COMFORT feature” and you wish the door being locked and the window being closed
automatically at the same time by remote control, you can set the alarm feature
II-1
“with comfort feature”.
MEGA 2550 INSTALL
8