MAGBEAST 5 Safety Instructions And Operator's Manual - page 2
MAGBEAST 5
Operator’s manual for MAGBEAST 5 Drilling Machine
- 2 -
IMPORTANT SAFETY INSTRUCTIONS
WARNING
When using electric tools, basic safety precautions should always be followed to reduce risk of fire,
electric shock and personal injury.
READ AND SAVE ALL INSTRUCTIONS FOR FUTURE REFERENCE
Before use, be sure everyone using this machine reads and thoroughly understands this manual as
well as any labels or warning attached to this machine.
1.
Keep Work Area Clean
2.
Consider Work Area Environment
Do not expose power tools to rain.
Do not use power tools in damp or wet locations.
Keep work areas well lit.
Do not use tool in presence of flammable liquids or gases.
3.
Guard against Electric Shock
Prevent body contact with grounded surfaces. For example: pipes, radiators, ranges,
refrigerator enclosures.
4.
Keep Children Away
Do not let visitors contact tool or extension cord.
5.
Store Idle Tools
When not in use, tools should be stored in dry and high or locked-up place, out of reach of
children.
6.
Do Not Force Tool
It will do the job better and safer at the rate for which it was intended.
7.
Use Right Tool
Do not force small tool or attachment to do the job of a heavy -duty tool.
Do not use tool for purpose not intended - for example; do not use a circular saw for cutting
tree limbs or logs.
8.
Dress Properly
Do not wear loose clothing or jewellery; they can be caught in moving parts.
Rubber gloves and non-skid footwear are recommended when working outdoors.
Wear protective hair covering to contain long hair.
9.
Use Safety Glasses
Also use face or dust mask if cutting operation is dusty.
10.
Do Not Abuse Electrical Cord
Never carry tool by cord or yank it to disconnect from receptacle.
Keep cord from heat, oil and sharp edges.
11.
Secure Work
Use clamps or a vice to hold work. It is safer than using your hand and it frees both hands to
operate tool.
12.
Do Not Overreach
Keep proper footing and balance at all times.
13.
Maintain Tools with Care
Keep tools sharp and clean for better and safer performance.
Follow instructions for lubricating and changing accessories.
Inspect tool cords periodically and if damaged, have repaired by authorized service facility.
Inspect extension cords periodically and replace if damaged.
Keep handles dry, clean and free from oil and grease.
14.
Disconnect Tools
Unplug when not in use, before servicing and when c hanging accessories, such as blades,
bits and cutters.
15.
Remove Adjusting Keys and Wrenches
Form habit of checking to see that keys and adjusting wrenches are removed from tool before
turning it on.
16.
Avoid Unintentional Starting
Do not carry plugged-in tool with fingers on switches.
Be sure switches are off when plugging in.