Magewell XI100XE-PRO User Manual - page 12
http://www.magewell.com
12 / 18
Copyright © 2009-2010 Nanjing Magewell Electronics Co., Ltd. reserves all rights
Notes: when “Auto Select Input Interface” is selected, if SDI,HDMI and YPbPr input
interfaces both have signal access, then SDI input is preferred, the following is HDMI and
the last one is YPbPr. You must select CVBS manually.
8.3.1.2. Signal Status
The relevant parameters of signal are shown, such as total number of rows, frame rate
(p is progressive scan, i is interlaced), mode, audio frequency.
8.3.2. Image Adjustment
By default, image is auto, but auto cannot achieve desired effect, such as black border,
unclear image, picture which needs clipping, it must be adjusted manually. After
adjustment, you can save the preset. Then you can apply preset values without adjustment
when the same signal accesses.
For example as VGA signal adjustment:
Black border adjustment: Through adjust left margin and top margin to eliminate
black border. Every time you can adjust 1 pixel.
Text definition adjustment: adjust line number of samples and sampling phase to
achieve desired definition of text.
Select correct resolution quickly: the capture card cannot identify correct resolution
with the same number of rows, such as 1024x768, 1280x768, 1360x768, 1368x768,lines
are all 768, auto may be all identified as 1024x768, then click “auto”, a list will pop
up as shown below, user can select the correct resolution.。
Figure 10, auto pop-up menu
Image clipping: Through adjust image width, height, left margin and top margin to
achieve desired requirement. Increasing/reducing width of image starts from right,
increasing/reducing
height
of
image
starts
from
below.
Skills of image clipping as follows:
1. Set scale full output image to confirm whether clipping adjustment is appropriate.