Magic Chef mCSCd6W5 User Manual - page 21
21
Unsatisfactory
Washing
The dishes are
not clean
Improper wash
program selected
Select a more intensive program Refer to “Wash Cycle
Table”
Not enough detergent
was dispensed
Use more detergent, or change your detergent
Items are blocking the
path of spray arms
Rearrange the items so that the spray arms can rotate freely
The filter system
in the base of wash
cabinet is not clean or
is not correctly fitted
This may cause the
spray arm jets to get
blocked
Clean and/or fit the filter correctly Clean the spray arm jets
Refer to “Dishwasher Care” section
Glassware is
cloudy
Combination of soft
water and too much
detergent
Use less detergent if you have soft water and select a short
cycle to wash the glassware and to get it clean See “Wash
Cycle Table”
Black or gray
marks on dishes
Aluminum utensils
have rubbed against
dishes
Use a mild abrasive cleaner to eliminate the marks
Detergent left in
dispenser cups
Dishes blocking deter-
gent cups
Re-load the dishes properly See the “Loading the Dish-
washer” section
Unsatisfactory
Drying
The dishes are
not drying
Dishes not loaded
correctly
Load the dishwasher as suggested in the directions
Too little rinse aid
Increase the amount of rinse aid or refill the rinse aid
dispenser
Dishes removed too
soon
DO NOT empty your dishwasher immediately after washing
Open the door slightly so that the steam can escape Begin
unloading the dishwasher only once the dishes are cool
enough to touch Empty the low basket first This prevents
water from dripping off dishes in the upper basket
Wrong program
Selection
Short wash cycles use lower temperatures which lessen
performance Choose a longer wash program
Using cutlery with a
low-quality coating
Water drainage is more difficult with these items Cutlery
or dishes of this type are not suitable for washing in the
dishwasher
ERROR CODES
Codes
Meanings
Possible Causes
E1
Longer water inlet time
Faucet not fully open
Water intake restricted
Low water pressure
E4
Overflow
Dishwasher is leaking
WarNING
:
If overflow error occurs, turn off the main water supply before calling for service If there is water
in the base from an overflow or leak, the water should be removed before restarting the dishwasher