Magic KOR-2060SP Service Manual - page 8
Technical Information of Operation
Page 7
6. Place the carafe with hot water on the keeping warm plate, press the “ON/OFF” button once, the
appliance enters the keeping warm state, you can adjust the temperature of keeping warm by pressing
temperature “+” or “-” button (the keeping warm temperature range is between 50℃~80℃), you can stop
keeping warm at any time by pressing “ON/OFF” button.
NOTE: The defaulted keeping warm temperature is 80℃, the keeping warm plate will cut off the power
automatically after 2 hours when temperature is 50℃~65℃; the keeping warm plate will cut off the power
automatically after 1 hour when temperature is 70℃~80℃ .
NOTE: Ensure power supply is turned off and power cord is taken down when water kettle and carafe are
not in use. If there has water on the coupler, unplug first and the connector must be removed. Make sure
the connector and inlet must be dried before the appliance is used again.
Boil-dry protect
Should you accidentally let the kettle operate without water, the boil-dry protection will automatically switch
off the power. If this occurs, allow the kettle to cool before filling with cold water before re-boiling.
Cleaning and Maintenance
Always disconnect the appliance from the power outlet before cleaning.Never immerse the kettle, power
cord or power base in water, or allow moisture to contact with these parts. Wipe the appearance of water
kettle and base
with a mild and damp cloth or cleaner, never use a corrosive cleaner. Immerse the carafe
and the inner of it in soapy water and then rinse it in tap water. Then wipe it dry.
CAUTION: Do not use chemical, steel, wooden or abrasive cleaners to clean the outside of the kettle.