Magic Mobility Jewel Owner's Manual - page 7
6.1 Power Assist Unit Controls
6.1.1
On/Off Light & Battery Condition Indicator
On top of the handlebar control there is a multi-function light (1). The light will be on
when the ON/OFF key is switched on.
This light also indicates the level of battery charge. When the unit is switched on, the
light goes through a sequence of colours – red, amber then green. Green indicates
the battery is fully charged. The battery requires charging once the light is amber. A
red light indicates the battery has reached a critical low level and should be
recharged at the earliest opportunity.
In the case of a fault, the light will flash a sequence. To re-set, switch off, wait a few
seconds and switch on again. If the fault has not cleared, contact your local dealer
or Magic Mobility.
6.1.2
Preset Speed Control
The preset speed control (3) controls the maximum speed of the power assist unit.
Turn in a clockwise direction to increase the speed and anticlockwise to reduce speed.
6.1.3
Speed Control Lever
The speed control lever (4) progressively controls the speed up to the preset limit.
The further the lever is depressed the faster the unit operates.
6.1.4
On/Off Key
The ON/OFF switch (5) has a removable key. Never leave the power assist unit
switched on when not in use or with an unattended user in the wheelchair.
6.1.5
Forward/Reverse Switch
The forward/reverse switch (6) allows the chair to be driven forward with the speed
control lever and reversing the switch enables it to be driven in reverse.