Magiglo EMPATHY 16” Installation, Servicing & User Instructions - 12.
Page 10 of 16
Light the fire using the method in the instructions and ensure that the pilot lights
consistently and the pilot flame envelopes the thermocouple. The pilot should hold in 10
seconds. Turn control to main burner, this should light smoothly within 10 seconds. Ensure
the valve gives adequate turn down and the thermostat bulb reduces the burner rate to
off when heated. The gas manifold pressures are factory preset using highly accurate
equipment and may be observed in the pressure test point on the valve. In the unlikely
event of the pressure being incorrect it may be reset (refer to dataplate for details), using a
manometer or other pressure testing equipment.
Locate thermostat bulb in a cool place away from the appliance and preferably outside of
any inglenooks, to ensure it is sensing room air temperature.
Run appliance for 10 minutes, ensuring burner flames settle evenly.
A combustion analysis check should then be carried out. Using an analyser to BS7927, first
zero the equipment and sample the entire width of the combustion product outlet. Ratio
of CO/CO2 should be less than 0.002 within 30 minutes. (20ppm CO per 1% CO2) A
reading of CO in the room centre should give a rise of less than 9ppm over ambient, peak
reading. The catalyst is unlikely to need replacement during the life of the heater but if the
combustion is suspect, disconnect the appliance and contact the manufacturer. See the
additional information on testing found on pages 13 & 14.
12.
PARTS LIST
Part
Part No
Front Ceramic Coal
COA4241F
Rear Ceramic Coal
COA4241B
Front Ceramic Pebble
PEB4241F
Rear Ceramic Pebble
PEB4241B
OXY NG
OXYP4‐41‐D
OXY LPG
OXYP4‐51‐E
Glass
GLA4140
Grill
GRI4240
90mm Freestanding Spacer
SPACERKIT
Rechargeable Battery
BAT4240
Remote Handset
REM4240
USE ONLY GENUINE REPLACEMENT PARTS.
Parts ordered from our factory will normally take 5 – 7 working days to be delivered.
An ‘Express service’ is available upon request at an additional cost.
Due to our policy of continual improvement and development the exact accuracy of descriptions
and illustrations can not be guaranteed.
Burley Magiglo are the only company to bench run and thoroughly test every single Flueless gas
fire it produces. Burley Magiglo is in the unique position of knowing that every appliance leaves
the factory in perfect working order.