Magiglo EMPATHY 16” Installation, Servicing & User Instructions - page 7
Page 7 of 16
7.
REMOVING AND REFITTING GLASS & DECORATIVE TRIM
7.1
To remove the glass, remove the decorative trim and then the 4 nuts in the side frames
and pivoting it out from the bottom then remove glass from its top channel. Refitting is
done in reverse order.
7.2
REVERSIBLE SIDE CHEEKS The appliance has side cheeks that are plain on one side and
brick effect on the other. These can be removed and replaced by the installer to suit the
customer’s choice
7.3
Refit all decorative trims and fire front components before use. The fire front has tags
internally that simply clip over the cut outs in the glass clip. These tags can be bent to
adjust if required. Lift the trim assembly halfway up the fire, press back and then slide
down and the tags will clip on the enamelled glass channels.
8.
FUEL BED LAYOUT
The layout of coals and pebbles on this
appliance are identical, the only difference
being the surface moulding and decoration.
The base and front mouldings should be
positioned as shown. The base locates onto
the rear shelf and sits central and pushed
back. The front moulding is positioned
centrally in its channel with the cut out on
the right as shown.
Note the pilot position on the right hand
side of the burner.
It is important for clean burning that the correct moulding is fitted in the correct place.
There must be a clear gap between the two sets of coals / pebbles.
Always replace the glass after laying the fuels. Do not attempt to use the unit with broken
/ damaged glass or coals. Do not use additional or non standard coals or pebbles.
9.
TO LIGHT THE HEATER
BEFORE LIGHTING. IF THE PIPES HAVE NOT BEEN PURGED OF DEBRIS, DO SO NOW
BEFORE LIGHTING THE FIRE. FAILURE TO DO SO WILL RESULT IN BLOCKAGES WITHIN THE
PILOT.
BURLEY MAGIGLO IS THE ONLY COMPANY TO BENCH RUN AND THOROUGHLY TEST
EVERY SINGLE GAS FIRE IT PRODUCES. MAGIGLO IS IN THE UNIQUE POSITION OF
KNOWING THAT EVERY APPLIANCE LEAVES THE FACTORY IN PERFECT WORKING ORDER.
9.1
There are 2 control knobs on the appliance. The left
hand one (coloured black) controls On / Off and High /
Low flame. The right hand one (coloured black) is the
comfort level thermostat which turns the fire down to
pilot only once the desired temperature is reached.
Some people prefer to retain a flame effect using the
left hand black knob to control its height whilst keeping
the thermostat black knob set on hot. Others prefer to
use the fire purely as a heater in which case they will
select a flame height on the left black knob then set the thermostat black knob to a
comfort level. In both cases if the room gets too hot, the thermostat will automatically
M
H
L
Control Knob
Thermostat