Magma A10-205 Owner's Manual - Maintenance
MAINTENANCE
7
Complete Disassembly for Cleaning
1 - Remove entire grill body from L-Bracket of Mount.
2 - Unthread and remove burner, Flame Deflector and grease tray from bowl.
3 - To reassemble, reverse above steps and steps 6 through 9 from page 4 “Setting Up Your Grill”.
Stainless steel contrary to popular belief can rust. Most commonly, deposits on surface of the
product will trap moisture. It is this moisture that robs stainless steel of oxygen. Oxygen is the
element that reacts with stainless steel to form a protective layer of chrome oxide. Robbed of
oxygen, this reaction does not take place and “crevice corrosion” or “surface rusting” occurs. To
minimize this effect, thoroughly clean your grill with soap and water, rinse with fresh water, and dry.
Avoid using stainless steel polishes on grill exterior as most leave a residue that may discolor when
grill is heated.
Additionally, stainless steel that is exposed to high heat will change color and texture over time.
The “amber” color of grill exterior and internal components is not a failure of the stainless steel and
will not affect products operation. When this happens, we recommend using “Magma Magic”
Grill Restorer to remove the “amber” color and return grill to its original luster. However,
prolonged exposure to extreme high heat will cause chromium and nickel to “burn out” of stainless
steel. At this point stainless steel will become more susceptible to corrosion and will start to
deteriorate. We recommended replacement of internal components as they become seriously
deteriorated.
We recommend thoroughly cleaning grill and internal components after each outing.
Disassemble interior components and remove all food residue. Use a “Scotch Brite” pad or similar
product and “Easy-Off” oven cleaner for cleaning grills interior components, followed by thoroughly
washing with soap and water, rinse with fresh water & dry. AVOID CONTACT OF OVEN CLEANER
WITH SKIN, CONTROL VALVE, AND BOAT SURFACE. CAUTION: DO NOT USE ANY TYPE OF ABRASIVE
PAD ON EXTERIOR MIRROR FINISH AS IT WILL SCRATCH SURFACE, USE ONLY A SOFT CLOTH. We
recommend covering grill between uses. Grill covers are available at Magma retailers or directly from
Magma. See our website, www.magmaproducts.com
Grill Grates
Clean with brass wire brush while grill is warm. Use Oven & Grill cleaner for burnt-on residue. Wash
with soapy water and dry prior to storage.
Control Valve
All valves are set and tested at our factory. Do not attempt to adjust or disassemble the valve. Call
Magma if you suspect it is not adjusted properly. Clean valve with a cloth and remove any debris
obstructing the orifice.
Repair/Replacement Parts
All replacement parts are readily available at your Magma Retailers or directly from Magma. For a
complete list of replacement parts, see page 8, or visit our website www.MagmaProducts.com.