Magma A10-207 Owner's Manual - Connecting Fuel Source
CONTROL VALVE REGULATOR
•Uses standard 1-lb. disposable propane canisters (DOT-39 NRC 228/286).
•Prior to installing valve, become familiar with the valve function and graphics on valve
knob. Never force the knob.
Always turn or push gently.
•Turn control valve to “lock ”
and install gas canister being
careful not to cross the
threads. Prior to “each” use
by installing fuel canister, with
valve on “OFF “ position, brush soapy water solution
around threads and orifice hole checking for bubbles.
7 Install radiant plate & dome over burner on fire pan ridge.
8 Install grill grate by rotating grate so that both grill grate tabs slide under the holding clips (8a),
locking grate and all internal components in correct position.
9 Insert the turbo venturi tube into the threaded pipe on the bottom of the grill body and firmly
tighten the holding nut so it doesn’t turn when rotating valve. Venturi tube should be stowed with
valve in a clean dry environment when not in use. (See Stowing Tips” page 6) Prior to inserting
venturi tube, before each use, check that the threaded pipe is free of spider web obstructions.
CONNECTING FUEL SOURCE
High
Low
Medium
Indicator
Lock
Off
Unlock
OFF/
Lock
ON
•Position valve with gas bottle as shown (A). Gently insert valve stem into the turbo
venturi tube. Rotate until valve stem key aligns with lock detent allowing valve to fully
insert. Rotate gas canister down (B).
4
Align valve stem
key way to valve
lock detent in
venturi tube
and rotate.
8
7
8a
9
A
B
Valve Stem Key
Lock Detent