Magnacoustics Genesis ULTRA Installation Manual - page 11
11 |
Magnacoustics Inc™ © 3/2008 rev-o
Genesis ULTRA Installation and Connections continued
13:
A. For Horizon LX remove run 788 from J7 on the WIM Module and connect to the open
connector on the AutoVoice Breakout Box, then connect the other end of “CB4” to J7 on the
WIM. For 5X Console remove the cable going to J9 on the Auto Voice Board and connect to
the open connector on the AutoVoice Breakout Box, then connect the other end of “CB4” to J9
on the Auto Voice Board.
B. For Excite systems remove Run 1085 labeled OW1-A21-J7 from J7 on the Wim Module and
connect to the open connector on the AutoVoice Breakout Box, then connect the other end of
“CB4” to J7 on the Wim. For 5X console remove the cable going to J9 on the Auto Voice
Board and connect to the open connector on the AutoVoice Breakout Box, then connect the
other end of “CB4” to J9 on the Auto Voice Board.
14: Connect the receptacle side of cable “CB8” 6ft AC Adapter Cable to J12 on the rear of Genesis
module and DO NOT PLUG INTO AC OUTLET UNTILL ALL CONECTIONS ARE MADE. Also
ensure that the power entry receptacle is set up for your proper voltage 110 / 220.
15: Connect FM and AM Antenna to the Stereo Reference Antenna Connections in the Stereo
Instructions for proper installation of FM / AM Antenna Do Not Connect any external
Antenna Grounds to the Stereo (A ground loop will be created and you will hear a 60 Hz
Hum) If using building Antenna or Cable install a 75 to 300 ohm adapter to eliminate any
loops and only connect 1 wire
16: For GE MRI’s remove block off plate from J53 or J52 at penetration panel, all others use
supplied kit or fabricate a DB9 slot for filter as required.
17: Install RF filter with female toward computer room.
18: Locate existing electrical conduit between control console and computer room.
CAUTION
Assistance may be necessary to ensure Trauma free installation of cable CB1
19: Route and install Cable “CB1” (90 ft. DB9 Male to Female) with Female connector toward
Genesis Module and Male toward penetration panel.
20: Connect “CB1” Male to the RF filter
21: Zip tie cable “CB1” to existing supports, or cables from penetration panel to provide strain relief.
22: Connect Female end of cable “CB1” to J11 on the rear of Genesis module.
23: From scan room side of penetration panel connect either end of cable “CB2” (50ft. DB9 Female
to Female) to the RF filter you installed on penetration panel.
24: Zip tie cable “CB2” to existing cables from penetration panel to provide strain relief.
25. Route cable “CB2” on opposite side of the cold head (if used) to the front of the MRI utilizing
existing conduits.
26: Leave approximately 18 in. of cable “CB2” protruding from the front center of the MRI directly
above the table docking mechanism, or alongside the base of the gantry. It is important to
locate the end of “CB2” as close as possible to the front center of the bore.
27: Connect cable “CB2” to the Transducer and place it on the pedestal above the height control
peddles, or locate the Transducer as close as possible to the front center of the bore.