Magnacoustics Genesis ULTRA Installation Manual - page 8

8 | 

Magnacoustics Inc™ © 3/2008 rev-o 

Pre Installation

Mean Time to Install 

Allow 3 man-hours for unpacking, installation, checking and setting up of Genesis ULTRA MRI Music 

System. 

Additional time may be required when difficult ducting of cables is encountered. 

Recommended service tools for installation: 

1.  Nut Driver set 

2. Pliers 

3. Screw Drivers 

4. Razor Knife 

6. Electrical Tape 

7.  100 ft. Electrical Snake (fish tape) 

System Parts List 

Genesis ULTRA is supplied complete with all necessary cables to simplify quick installation.  After 

unpacking, check for the following items: 

1:    AM/FM Multi-Disc CD Changer. 

2:    One AM antenna. 

3:    One FM antenna. 

4:    Two Speakers. 

5:    One Transducer Module (houses connections for Headsets, Patient Volume control, Patient 

selection control, and Mic connection for Active volume stabilization.) 

6: 

One Gradient MIC (Blue cable with BNC and Black Mic.) 

7:    One Clear Siamese Headset tubing to (Link Transducer to Headset.) 

8:     Ten Headsets. 

9:   Patient volume control Red and Green buttons. 

10:   Patient selection control Blue and Yellow buttons. 

11:   CB1 - 90 ft. DB9 Female to Male DB9 Cable (Links Genesis Module to Penetration Panel.) 

12:   CB2 - 50ft. DB9 Female to Female DB9 Cable (Links from Penetration Panel to Transducer.) 

13:   CB3 - 10ft. DB9 to Male AMP Cable (Links Breakout Box to Genesis Module.)