Magnadyne M9970 Installation And Operating Instructions Manual - Receive A Call
17
Receive a Call
By default, all incoming calls are received automaticaly.
1. If there is an incoming call,
“Incoming call...” will appear
on the screen
.
2. You may touch the screen to select [ Hang up ] or
[ Answer ].
Speak into the Bluetooth microphone.
Tip
• You can select to receive calls manually by setting [Auto
answer] to [Off] status.
Adjust Bluetooth Settings
1. In Bluetooth menu, touch [
].
The option menu is displayed.
2. Touch on the selected option to change the setting.
∙ [Bluetooth]: To turn on or off “Bluetooth” function.
∙ [Auto connect]: To turn on or off “Auto connect” function.
∙ [Auto answer]: To turn on or off “Auto answer” function.
∙ [Pairing code]: To set paring code.
∙ [Phone book sync]: To synchronize phone book, touch
[ OK ] on the sub-menu popped
out.
Phonebook sync may take several minutes to load on
initial setup.
Tip
• You can also adjust Bluetooth settings in the “Settings”
menu.
Music Mode
A2DP
A2DP is short for Advanced Audio Distribution Profile. The
mobile phones supporting this function can transmit stereo
audio, whereas the ones not supporting this function can
transmit mono audio only.
AVRCP
AVRCP is short for Audio/Video Remote Control Profile.
The mobile phones supporting this function can control the
playback of a Bluetooth audio player.
To make a call in music playing mode, press the number
keys on the mobile phone and the music player will stop.
“Calling” will be displayed on the TFT and once the call
is received the caller audio will be transferred to the unit.
When the call ends, the screen will display the music
playing menu.
If there is an incoming phone call, the music player will stop
and the screen will display “Incoming”. When the call ends,
the screen will display the music playing menu.
Bluetooth Mode
18
Display System
1. Touch the upper left corner to display the main menu.
2. Touch [ Settings ].
The settings menu is displayed.
Adjust General Settings
1. Touch [ General ], if necessary.
2. Touch to highlight a setting.
3. Touch to display/select an option.
4. Touch blank area of the screen to close the sub-menu.
General settings Options
Description
Radio region
Select one that matches your location.
Radio range
Local
Select Local to receive only stations with extremely
strong signal.
Distance
Blackout
Off/10s/20s
Set the screensaver.
Dimmer mode
Night/Dark/Normal/Bright
Adjust the display brightness.
Beep
On
Turn on the beep sound. Each time you press a button,
the unit beeps.
Off
Turn off the beep sound.
Calibration
Start
Calibrate the touch screen.
TFT open
Auto on
Turn TFT open Auto on
Auto off
Turn TFT open Auto off
Manual
Turn TFT open Manual
Calibration
When the touch operation is not sensitive or valid, you should
calibrate the touch screen using the calibration setting function.
Adjust the response positions of the touch panel as followings:
1. Press the [ Calibration ] option on the setup menu to enter.
2. Touch [ Start ] to enter.
3. Press and hold the center of [
+
] for 2 seconds, the [
+
] will move
automatically.
4. Aim at center of [
+
], follow the path as shown in the figure.
Once steps 1-5 are complete the system will automatically exit
calibrating mode.
Adjust Video Settings
1. Touch [Video].
2. Touch an option repeatedly to select:
Settings
Video settings
Options
Description
parking
On
Disable video when driving.
The playback of movies and images on the device display is allowed only while the vehicle is
parking. If you play movies and images when driving, the screen shows Warning information.