Magnat Audio MA 800 Important Notes For Installation & Warranty Card - page 10
• Connect your audio sources to the analogue connections.
• Connect the supplied mains cable to the rear and then insert the other end into a 230V socket.
• Turn the volume knob to the left to a low volume setting.
• Actuate the on/off switch on the rear side, the device is now in the standby mode.
• Switch on the MA 800 using the ON/STANDBY button on the front panel or the remote control.
• When the tubes have heated up the device is ready for use.
• Select your desired audio source using the input selector switch.
PROTECTIVE CIRCUIT
To ensure maximum protection for the amplifier and the connected speakers the MA 800 is equipped
with a protective circuit. In the event of a short circuit, overcurrent or DC offset it separates the speaker
outputs from the amplifier. In this case “
PROTECT
“ is indicated in the display. The device must be
disconnected from the power supply and the cause of the malfunction determined. Start by checking
the wiring of the speakers. If the malfunction occurs again, please contact a specialist and get the
amplifier and/or the speakers checked.
The device has a high quality preamplifier stage which is equipped with two tubes. The tubes have a
very long service life when used under normal operating conditions (min. 20,000-50,000 hours).
If it is necessary to replace the tubes, please refer to a specialist dealer.
If you should encounter any technical problems, please contact your specialist dealer or Magnat
Audio-Produkte GmbH, Tel.: 02234807-0.
SERVICE AND TECHNICAL PROBLEMS
TUBE REPLACEMENT
Amplifier
Power output:
Rated power
20 Hz – 20 kHz, THD
2 x 110 W
20 Hz – 20 kHz, THD
2 x 75 W
Peak power:
1 kHz, 4 ohm
2 x 200 W
Frequency response :
5 Hz – 100 kHz (-3 dB)
20 Hz – 20 kHz (+/- 0,1 dB)
Phono
20 Hz – 20 kHz (+/- 0,3 dB)
Subsonic filter: 16 Hz, 18 dB/octave
Signal to noise ratio:
CD/Tuner/Aux/Line/Tape
110 dB
Phono MM
88 dB
Phono MC
75 dB
Input sensitivity/impedance:
CD/Tuner/Aux/Line/Tape
400 mV / 100 kohm
Phono MM
2 mV / 47 kohm
Phono MC
0,3 mV / 470 ohm
Fitted with
:
Phono Preamplifier:
2 x ECC 82
Miscellaneous
Mains voltage:
230 VAC / 50 Hz
Electricity consumption:
Max. 250 W
Standby 1,0 W
Dimensions (wxhxd):
Main device:
430 x 125 x 330 mm
Main device incl. operational
elements/connecting terminals: 430 x 125 x 380 mm
Remote Control:
45 x 190 x 23 mm
Weight:
11 kg
Subject to technical change.
For further information please visit our website: http://www.magnat.de.
SPECIFICATIONS
GB
10