Magnavox 15MF605T - 15" Lcd Tv Quick Setup Manual

Other manuals for 15MF605T - 15" Lcd Tv: Specifications, Owner's Manual, Owner's Manual, Specifications

Manual is about: User Manual

Page of 8

Download

Print this page

Bookmark us

LCD TV

3138 155 23293

TV C

HANNEL

NSTALLATION

AUTO STORE

PLEASE WAIT

PROG.FOUND

CHANNEL

C C

SOURCE

P I P

M E N U

INSTALL

LANGUAGE

TUNER MODE

AUTO PROGRAM

CHANNEL EDIT

FACTORY RESET

cable

INSTALL

LANGUAGE

TUNER MODE

AUTO PROGRAM

CHANNEL EDIT

FACTORY RESET

START?

MANUAL FINE TUNE

MAIN CONTROLS

PICTURE

AUDIO

FEATURES

INSTALL

LANGUAGE

TUNER MODE

AUTO PROGRAM

CHANNEL EDIT

FACTORY RESET

MANUAL FINE TUNE

Please follow these steps to install TV channels:

Select a TV channel via SOURCE button on your remote control.

Press MENU button on your remote control to open the onscreen menu.

Press CH(-) to move to INSTALL,press VOL(+) on your remote control to enter

INSTALL.

Press CH(-) to select TUNER MODE, press VOL(+) on your remote control to

select CABLE, ANTENNA or AUTO mode.

CABLE

IF you have a cable input

ANTENNA IF you have an antenna input

AUTO

IF you are not sure what kind of TV signal input you have

(Cable or Antenna)

Press CH(-) to move to AUTO PROGRAM.

Press VOL(+) to start auto install the TV Channels.

For more detailed explanation of AUTO PROGRAM, please refer to

AUTO PROGRAM section on page 5.

Immediately after unpacking and plugging in your new television, run the auto program function

to set up the TV for the broadcast or cable channels available in your area. If you do not run the

auto program function to set up the channels , your television may not operate properly.

Expanding the base requires a degree of force; please use sufficient force to unfold the base.

When unfolding the base, place the TV on a flat, sturdy surface before expanding the base.

NFOLD

THE

ASE

1 2 3 4 5 6 7 Next › »

Summary of 15MF605T - 15" Lcd Tv

Page 1
Lcd tv lcd tv 3138 155 23293 1 tv c hannel i nstallation auto store please wait prog.Found 0 channel 3 c c source p i p m e n u ok install language tuner mode auto program channel edit factory reset cable install language tuner mode auto program channel edit factory reset start? Manual fine tune man...
Page 2: Lcd Tv
2 lcd tv lcd tv quick use and hookup guide s - video video side jack panel of television audio c ontents important note: this quick setup guide is used with several different lcd tv models. Not all features (and drawings) discussed in this manual will necessarily match those found with your lcd ...
Page 3
3 b attery i nstallation remove the battery compartment lid on the back of the remote. Place two aaa batteries in the remote. Be sure the (+) and (-) ends of the batteries line up as marked inside the battery compartment. Reattach the battery compartment lid. 1 2 3 r emote c ontrol o peration ...
Page 4: Direct Cable Connections:
4 a ntenna tv a combination antenna receives normal broadcast channels (vhf 2–13 and uhf 14–69). Your connection is easy because there is only one 75 Ω (ohm) antenna jack on the side of your tv, and that’s where the antenna goes. If your antenna has a round cable (75 ohm) on the end, then you’re rea...
Page 5: �
T uner m ode c ontrol the tuner mode allows you to change the lcd tv’s signal input to cable or air (antenna). It’s important for the lcd tv to know if you want to receive channels from a cable tv signal or an antenna signal. Main controls picture audio features install language tuner mode auto prog...
Page 6: Rf I
6 c able b ox ( with rf i n / o utputs ): connect the cable tv signal to the in jack (or rf in or cable in) on the cable box. Connect an rf coaxial cable (not supplied) to the out jack (or to tv or rf out) of the cable box. Connect the other end of the coaxial cable to one end of the supplied l-adap...
Page 7: �
7 c c source p i p m e n u ok accessory device equipped with component video outputs. component video input provide the highest possible color and picture resolution...
Page 8: �
8 this lcd tv can be used as a pc. Your computer will have to be equipped with a vga type video output and vga cable. Connect one end of the vga video cable (not supplied) to the monitor (video) output on the computer, while connecting the other ends to the vga input jack on the lcd tv. Although aud...