Magnavox MC348 Owner's Manual - page 4
BATTERY PRECAUTIONS:
Follow these
Battery Precaution
when using a battery in this device:
1. Use only the size and type of battery specified.
2. Be sure to follow the correct polarity when installing the battery as indicated in the
battery compartment. A reversed battery may cause damage to the device.
3. Do not mix different types of batteries together (e.g. Alkaline and Carbon‐zinc) or old
batteries with fresh ones.
4. If the batteries in the device are consumed or the device is not to be used for a long
period of time, remove the batteries to prevent damage or injury from possible
battery leakage.
5. Do not try to recharge the battery not intended to be recharged; it can overheat and
rupture. (Follow battery manufacturer’s instructions.)
6.
Do not dispose of battery in fire. Battery may explodes or leak.
7. Clean the battery contacts and also those of the device prior to battery installation.
SETTING UP:
You must set up the Universal Remote before operating with your device as follows:
Setup with device code:
1. Use only the size and type of battery specified.
2.
Power on your desired device (EX: TV) as usual.
3.
Find the four (4) digit device code for it in the attached Code List.
4.
Press and release the corresponding device’s selection button on the Universal
Remote (EX: TV Button).
5.
Press and hold the SET Button approximately 3 seconds until the LED Indicator is
illuminated then release the button.
6.
Enter the four (4) digit code for your device by pressing the numeric buttons. The LED
Indicator will turn off. (If the code is invalid, the Indicator will stay illuminated. Repeat
the setting procedures from 2‐5 again to reset a valid code.)
7.
Aim the Universal Remote to the remote sensor for your device then try operating the
device. If the device is responds correctly, it means you have entered the right code. If
not, check the provided code list for other codes that may apply to your unit. Start the
process again from Step 2.
NOTE:
If the codes provided do not work to pair the Universal Remote to your device, try the
following methods.
3