Magnavox MC348 Owner's Manual - page 6
Manually setting:
1. Power on your desired device (EX: TV) as usual.
2. Press and release the corresponding device’s selection button for your desired device
(EX: TV Button).
3. Press and hold the SET Button approximately 3 seconds until the LED Indicator is
illuminated then release the button.
4. Aim the Universal Remote to the remote sensor of your device (EX: TV) then press
the CH + or – buttons on the Universal Remote repeatedly to send different infrared
signals; LED Indicator will blink.
5. Once your device is shut off, press the OK Button to save the settings and exit, the
LED Indicator will turn off.
6. Aim the Universal Remote to the remote sensor for your device (such like TV) then
operation the device with the Universal Remote.
OPERATION:
1. Repeat the setting procedure until all desired devices (up to 8 devices) was been set.
2. Press the desired device selection button (EX: TV) on the Universal Remote.
3. Aim the Universal Remote to the remote sensor of you device then operation the
device with the Universal Remote.
NOTES:
1. Buttons may be titled differently on your Universal Remote from the titles on the
original manufacturer's controller.
2. Some of buttons may not respond as your original remote.
3. If the Universal Remote is halt, abnormal operation or you wants to reset all settings.
Reset the Universal Remote by take out all batteries approximately 1 minute then
reinstall the batteries.
5