Magnavox MME100 - Audio Micro System User Manual - Radio Reception
16
English
8240 009 34241
Radio Reception
Tuning to radio stations
1
Select TUNER source.
➜
TUNER is displayed briefly.
2
Press down on TUNING
à or á and release
button.
➜ The radio automatically tunes to a station
with sufficient reception. Display indication during
automatic tuning:
SEARCH.
➜ If a FM station is received in stereo,
STEREO
is
shown.
3
Repeat step 3 if necessary until you find the
desired station.
● To tune to a weak station, press TUNING à
or
á briefly and repeatedly until you have
found optimal reception.
Programming radio stations
You can store up to a total of 40 radio stations
in the memory.
Automatic programming
Automatic programming will start with a chosen
preset number. From this preset number
upwards, former programmed radio stations will
be overridden. The system will only program
stations which are not in the memory already.
1
Press
9 / 3 PRESET or 2; / PRESET 4(¡1
/
2™ on the remote control) to select the
preset number where programming should start.
Note:
– If no preset number is selected, default is preset
(1) and all your presets will be overridden.
2
Press PROG for more than 2 seconds to
activate programming.
➜
AUTO is displayed and available stations are
programmed in order of waveband reception
strength: FM followed by AM. The last preset
automatically stored will then be played.
Manual programming
1
Tune to your desired station (see Tuning to radio
stations).
2
Press PROG to activate programming.
➜
PROGRAM
flashes in the display.
3
Press
9 / 3 PRESET or 2; / PRESET 4(¡1
/
2™ on the remote control) on the remote
control) to allocate a number from 1 to 40 to
this station.
4
Press PROG again to confirm the setting.
➜
PROGRAM
disappears, the preset number and
the frequency of the preset station are shown.
5
Repeat the above four steps to store other
stations.
● You can override a preset station by storing
another frequency in its place.
Tuning to preset radio stations
● Press
9 / 3 PRESET or 2; / PRESET 4(¡1
/
2™ on the remote control) until the desired
preset station is displayed.
pg001-024_MME100_37-Eng
11/20/2003, 03:58 PM
16