Magnavox Soundbar MSB4550 Owner's Manual - page 13
11
5.5
Auto Standby
When playing media from a connected device,
the SoundBar automatically switches to standby
after 20 minutes if no audio play from a
connected device.
5.6 Apply factory settings
You can reset your SoundBar to the default
settings programmed at the factory.
1
On your remote control, press LINE
INPUT button.
2
Press MUSIC, VOL- and NEWS on
remote control within 3 seconds to
perform factory default settings.
»
when the factory setting restore is
complete, the system shuts down into
standby mode and restart.
4
Select and play audio files or music on
your bluetooth device.
• During play, if a call is coming, music
play is paused. Play resumes when the
call ends.
5
To exit Bluetooth, select other source.
• When your switch back to Bluetooth
mode, Bluetooth connection remains
active.
Note
•
The music streaming may be interrupted by obstacles
between the device and SoundBar, such as wall, metallic
casing that covers the device, or other devices nearby
that operate in the same frequency.
•
If you want to connect your SoundBar with another
Bluetooth device, press PAIR button to disconnect the
currently connection.
5.4 Night Mode
Night Mode is a digital Audio feature equipped
with Dolby digital decoder. When you watch
movie late at night, lowering volume level
during loud sound scenes, dynamic range will
be pressed down and you miss some dialogue
and narration. With this “Night Mode” you can
control volume level down but still can enjoy
fair level of audio tone and voice.
1
In any mode, Long press CLASSIC on
remote control for 3 seconds to switch
night mode on or off.
»
The OPTICAL INPUT indicator on
the front panel of main unit blinks
three times when the night mode is on.
»
The OPTICAL INPUT indicator on
the front panel of main unit blinks once
when the night mode is off.
Note
•
This product supports Dolby Digital and LPCM.
•
DTS is not supported.
•
Sampling frequency: 32KHz, 44.1KHz, 48KHz
EN