MAGNAWELD MONOMAG 180 User Manual - page 10
2.3 WELDING CONNECTIONS
9
Monomag 180
2.3.1 Connecting the Earth Cable to the Workpiece
Topraklama pensesini, kaynak yapılacak bölgeye
olabildiğince yakın yerden iş parçasına sıkıca
bağlayın.
After placing the gas cylinder
on its platform,
fasten it with the gas cylinder safety chain
. To
operate safely and get best results use approved
gas regulators and heaters.
Open and close the gas cylinder valve
few
times in order to blow out any possible dirt or
particles.
If CO is going to be used, firstly connect the CO
heater
and then connect the gas pressure
regulator
to the gas cylinder
. Connect the
power cable of the CO heater to the CO heater
socket
at the back of the machine.
(20)
(18)
(21)
(26)
(19)
(20)
(7)
2
2
2
2
2.3.2 Gas Connections
Figure 3: Connections Gas Cylinder - Heater - Pressure Regulator
21
20
18
25
24
22
23
19
26
18
19
20
21
Gas Cylinder Safety Chain
Gas Pressure Regulator
Gas Cylinder
Gas Cylinder Valve
Gas Flow Adjustment Valve
22
23
24
25
26
27
Gas Hose
Flow meter
Manometer
CO Heater
Power Cable of CO Heater
2
2
27
Figure 4: Gas Connections
6
7
Connect one end of gas hose
to the gas
pressure regulator
and connect the other end
to the gas supply inlet
at the back of the
machine. Open the gas cylinder valve
.
Set the gas quantity with the pressure adjustment
valve
. For more information about gas
adjustment check the page 11.
(23)
(19)
(6)
(21)
(22)
INSTALLATION