MAGNEPLANAR MMC 2 General Instruction Manual - Speaker Angle Adjustment
6.
Speaker Angle Adjustment
For the best sound, the MMC 2 should be angled so that the panel is on-axis with the listener with a minimum
distance from the wall of 30 degrees. (Use of the MMC 2 as a dual center channel speaker requires slightly
different adjustments. Contact Magnepan for dual center speaker installations). Pull the MMC 2 out until you feel
the resistance of the Cam/Stop. Insert the long 5/64 inch allen wrench into the Cam/Stop at the bottom of the
speaker as shown in Fig. 1 and 2 below and loosen the allen screw. Rotate the MMC 2 to the desired position as
shown in Fig. 3 and 4 and tighten the allen screw.
The angle of the MMC 2 should never be set for less than 30 degrees for optimum sound.
The MMC 2 can be pushed past the stop position without causing harm to the speaker or motor system. The
MMC 2 will usually automatically reset back to normal operation after cycling the motor once or twice or if the
speaker is pushed beyond the stop position, the panel can be manually pushed back into position.
Fig. 1
Fig. 2
Fig. 3
Fig. 4