Magnetek Enrange XLTX User Manual - page 16
Enrange XLTX Intrinsically Safe
Transmitter Instruction Manual
April 2014
Page 16 of 24
NOTE: The LED should be continuously blinking at all times. If the LED is not blinking the
transmitter will need to be rebooted to operate properly.
3.5.2
Switch Change Indicator (Rapidly Blinking Status LED)
When a switch is actuated or a switch status changes, the status LED will blink rapidly during the
change.
NOTE: If a joystick, rotary switch, or auxiliary switch is held in position or latched, the status LED
will return to the steady watch dog indicator blinking state.
3.5.3
Low Level Battery Indicator (Blinking Red Status LED)
The status LED will turn red when the battery level drops below 10%. The status LED will
continue blinking for the watch dog indicator and switch change indicator status.
3.6
JOYSTICKS AND PADDLES/LEVERS
To activate the desired motor functions, operate the Joystick or Paddle/Lever that corresponds to
the desired motion.
To activate higher speed functions for those transmitter models so equipped, operate the Joystick
or Paddle/Lever further to activate the desired speed.
3.7
ROTARY SELECTOR SWITCH
The rotary selector switch can be used to select various modes of operation.
A rotary switch can have 2 to 12 positions to select from.
3.8 AUXILIARY
SWITCHES
These switches activate special function relays that control items such as grab attachments,
magnets, lights, and etc.
The auxiliary switches can be momentary or latched.